Makerbase Mks Dlc V21 Manual Link Fixed Jun 2026

| Function | Pin / Connector | Voltage/Signal | |----------------------|----------------------------------------|-------------------------| | Power input | VIN (2-pin screw terminal) | 12–24V DC | | USB-C | Firmware upload, serial | 5V (isolated) | | Stepper drivers | X,Y,Z,E0,E1 (optional E2) | TMC2209 UART addr 0–3 | | Hotend heater | HE0, HE1 | MOSFET 24V/10A max | | Heated bed | BED | MOSFET 24V/15A max | | Thermistors | TH0 (hotend), THB (bed) | Pull-up 4.7kΩ to 3.3V | | Endstops (X/Y/Z) | X-STOP, Y-STOP, Z-STOP | 3.3V logic, pull-up | | Fan ports | FAN0 (part cooling), FAN1 (controller) | PWM capable (12/24V) | | RGB port | JRGB (WS2812) | 5V data signal | | Probe / BLTouch | SERVOS + PROBE | 5V/3.3V selectable | | Wi-Fi module | ESP8285 on-board (UART2) | 3.3V, Serial2 |

Here are some tips and tricks to help you get the most out of your Makerbase MKS DLC V21: makerbase mks dlc v21 manual link

MKS-DLC/hardware/MKS DLC V2. 1_001/MKS DLC V2. 1_001 SCH. pdf at master · makerbase-mks/MKS-DLC · GitHub. DLC32 wiring manual.pdf - GitHub | Function | Pin / Connector | Voltage/Signal

The board includes dual Y-axis outputs, though note that Y1 and Y2 are reversed on some versions of the board. pdf at master · makerbase-mks/MKS-DLC · GitHub

Once connected via USB (usually at ), you may need to adjust these settings in the console: $100, $101, $102 : Steps per mm for X, Y, and Z. $32=1 : Enable Laser Mode (if using a laser).

: Provides a complete overview of power input, motor drive settings, and laser module connections. Download/View Manual (PDF via Solo Motor Controllers) MKS DLC32 V2.1 Wiring Manual (via Scribd) Full User Manual (GitHub)