Empi 300pv User Manual Top Jun 2026

Use the up/down arrows to set specific values like pulse rate, pulse width, and treatment timer (0–60 minutes).

Safety Note: If the intensity stays at a certain level for more than 10 seconds, it may lock to prevent accidental increases. Press the to unlock. Clinician Setup & Lock Features empi 300pv user manual top

| Problem | Likely Cause | Manual's Solution | | :--- | :--- | :--- | | | Dead battery, loose wire, dry electrodes | Replace battery, push wire firmly, replace electrodes. | | Weak/Intermittent stimulation | Old electrodes (dried gel) | Replace electrodes every 10-15 uses. | | Sharp, stinging pain | Electrode edges curling, or skin not clean | Replace electrode, wash skin with mild soap. | | LCD flickers/unit shuts off | Low battery or faulty adaptor | Install fresh 9V battery. | | Error code "E-1" | Lead wire short circuit | Unplug, inspect for frayed wires, replace lead wires. | | Error code "E-2" | Output overload (intensity too high with broken skin contact) | Turn intensity to zero, check electrode adhesion. | Use the up/down arrows to set specific values